458113
458113
458113
458113
458113

458113

Saniflo® 081 Macerator Pump, 1.28 gpf Flow Rate, 2 in Inlet, 0.5 hp

Manufacturer: Saniflo
Brand: Saniflo®
Lee Supply #: 458113
Manufacturer Part #: 081
UPC: 85992500281
Customer Part #:
Sold As: 1/PK
Carmel

Amperage Rating      :      4.5 A
Dimensions      :      18-3/4 in W x 6-3/4 in D x 10-3/4 in H
Flow Rate      :      1.28 gpf
Frequency Rating      :      60 Hz
Horsepower      :      0.5 hp
Inlet Size      :      2 in
Lee_Descr      :      #081 SANIFLO SANIACCESS 2 1/2HP MACERATING PUMP - HALF BATHROOM
Lee_UPC      :      85992500281
Temperature Rating      :      104 deg F
UPC_Lee      :      85992500281
Voltage Rating      :      115 V AC
Weight      :      15.0 lb
Width      :      19.25 in
Length      :      9.5 in
Height      :      13.25 in

The Saniaccess®3 is a 1/2 hp pump system used to install a complete bathroom up to 15 ft below the sewer line or even up to 150 ft away from a soil stack. It incorporates a macerating system which can handle human waste and toilet paper in residential applications. The blade is made out of a hardened stainless steel material which eliminates the need for any service or replacement.

Saniflo® Macerator Pump, 1.28 gpf Flow Rate, 2 in Inlet, 0.5 hp, 115 V AC, 4.5 A, 60 Hz Frequency, 104 deg F, 18-3/4 in W x 6-3/4 in D x 10-3/4 in H

  • The Saniaccess® 2 is ideal to create an additional half-bathroom anywhere
  • For half bathroom applications
  • 15 ft vertical and/or 150 ft horizontal discharge
  • Quietest pump on the market
  • Easy dual access service panels
  • Discharges the waste through a 3/4 or 1 in rigid pipe
  • Non-return valve is included on the discharge elbow assembly provided with the system
  • Elbow can be rotated 360 deg depending on the discharge installation
  • Has been designed with a 1-1/2 in vent connection on the top of the lid
  • All plumbing codes require connection to a vent system
  • Must be connected to Saniflo® 1.28 gpf rear discharge toilet
  • Will also discharge gray water from any sink, bath/shower or urinal
  • Wastewater will drain into the system via two 2 in inlets with built-in check valves on either side of the housing, note that when adding a bathtub/shower, the base should be raised up by a minimum of 6 in off the floor
  • 0.5 hp oil-filled thermally protected motor
  • 45 uF capacitor
  • 51 in power cord
  • ≤ 53 dBA noise level measured at 3 ft