85860
Bradford White® Defender Safety System® RG1PV50S6N TTW® Gas Water Heater, 40000 Btu/hr Heating, 50 gal Tank, Natural Gas Fuel, Power Vent, 43 gph Recovery, Domestic
| Dimensions | : | 22 in Dia x 27-3/16 in D x 58-1/4 in H |
| Domestic/Import | : | Domestic |
| Energy Factor | : | 0.63 |
| Fuel Type | : | Natural Gas |
| Gas Connection | : | 1/2 in |
| Heating Capacity | : | 40000 Btu/hr |
| Ignition Type | : | Pilot |
| Lee_Descr | : | BRADFORD WHITE - 50 GALLON SHORT POWER VENT GAS WATER HEATER - 40000 BTU RG1PV50S6N |
| Lee_UPC | : | 67163279483 |
| Pressure Rating | : | 150 psi |
| Recovery Rate | : | 43 gph |
| Series | : | TTW® |
| Tank Capacity | : | 50 gal |
| UPC_Lee | : | 67163279483 |
| Ultra Low NOx | : | No |
| Vent Size | : | 2 x 3 in |
| Vent Type | : | Power |
| Water Connection | : | 3/4 in NPT |
| Weight | : | 166.0 lb |
| Width | : | 22.5 in |
| Length | : | 27.5 in |
| Height | : | 59.25 in |
Our Power Vent (TTW®) models are power vented for positive exhaust. They offer greater installation flexibility with the ability to vent through a wall or roof, with either 2 or 3 in PVC, ABS or CPVC pipe. They offer an increased amount of hot water available at a usable temperature in less time than normal.
Bradford White® Defender Safety System® Gas Water Heater, Series: TTW®, 40000 Btu/hr Heating, Natural Gas Fuel, 1/2 in Gas Connection, 50 gal Tank, Pilot Ignition, Power Vent, 2 x 3 in Vent, 43 gph Recovery Rate, 0.63 Energy Factor, 3/4 in NPT Water Connection, 150 psi Pressure, Ultra Low Nox: No, 22 in Dia x 27-3/16 in D x 58-1/4 in H Dimensions, Domestic
- Bradford White® ICON System™: Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot, this results in savings of pilot gas during stand-by periods (120 VAC)
- Enhanced performance: Proprietary algorithms provide enhanced first hour delivery ratings and tighter temperature differentials
- Advanced temperature control system: Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels
- Intelligent diagnostics: An exclusive green led light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting
- Power vent water heater: Designed for installations where atmospheric units cannot be used, exhaust gases are vented under positive pressure directly out of the building through the roof or the wall
- Powerful blower motor: Our significantly quiet design has greater resistance to outside winds and the power to vent in many difficult venting situations
- Horizontal and vertical venting: PVC, ABS or CPVC
- Advanced ScreenLok® technology flame arrester design: Flame arrester is designed to prevent ignition of flammable vapor outside of the water heater
- Flammable vapor sensor: Electronic sensor prevents burner operation if flammable vapors are detected
- Maintenance free: No regular cleaning of air inlet openings or flame arrester is required under normal conditions
- Sight window: Offers a view into the combustion chamber to observe the operation of the pilot and burner
- Factory installed Hydrojet® total performance system: Sediment reducing device that also increases first hour rating of hot water while minimizing temperature build-up in tank
- Vitraglas® lining
- Insulation system: Non-CFC foam covers the sides and top of the tank, reducing heat loss, this results in less energy consumption, improved efficiencies and jacket rigidity
- Water connections: 3/4 in NPT factory installed true dielectric fittings extend water heater life and simplify water line connections
- Factory installed heat traps: Design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation
- Low restriction brass drain valve: Durable tamper proof design
- Protective magnesium rod
- FVIR defender safety System®
